Newsblog Über GEBLA Galerie Rohbox-Order Rohbox-Technical Manuals Kontakt/Impressum

Rohbox: Modification for SRAM BrakeShiftLevers (Brifters)

To use SRAM Brifters for the Rohbox shiftbox the holding pawl have to be removed.hse, It is located on its own axle which is fixed with a c-clip. The spring of the holding pawl will be removed also.

Tools neded:

1 Small Phillips Screwdriver

1 Small Flat Screwdriver

Flip over the hoodie, it does not have to be removed. The red arrow shows the axle that has to be removed. The holding pawl sits on it, inside the housing.

Depending on the model 3 or 4 cover screws have to be removed.

Now the holding pawl with spring is visible:

On top of the axle the c-clip is located. Remove it using a little screwdriver. Be careful, it likes to jump in corners to be never found again.

The c-clip removed:

Now the axle can be removed in the direction of the green arrow:

Now the holding pawl and the spring can be removed. From left: c-clip, axle, spring and holding pawl.

Assemble the cover again.

Put the parts in a lille bag in case the Brifter will be used for a deraillieur again.

Now the same on the other side and ready you are!

Best Regards,

Georg Blaschke 

 

 

 

 

 

All content © 2004-2015 Georg Blaschke